Sensor parameters

Note: document contents may change due to software changes or updates without any notice.

Visit sensors section to learn more about sensors configuration.

Auto detection

Server detects available device sensor parameters automatically, but user should configure them manually. This allows user to choose which sensors to monitor.

1. Make sure all needed sensors are connected to GPS device, for example: ignition, doors, fuel, inputs, outputs and etc.

2. Drive your vehicle, turn on and off ignition, open and close doors and so on.

3. Server will auto learn and detect all possible sensor parameters.

4. Detected sensor parameters will appear in sensor properties Parameter select box.

Description

Below are listed most common sensor parameter names, still they vary depending on GPS device model and capabilities.