Accuracy

In edit object window click on Accuracy tab. This section allows to accurately adjust GPS device data.

• Time zone offset - by default it should be set to (UTC 0:00), adjust only in case it is not possible to set (UTC 0:00) time zone on GPS device side.

• Detect stops using:

  • GPS - calculates stops using GPS location points.

  • ACC - calculates stops according to ignition sensor state, ignition sensor must be set up properly. Learn more about sensor parameters.

  • GPS + ACC - stops are being calculated according to both options.

• Min. moving speed in km/h - set minimum movement speed. Very important to set proper value if object is moving slowly (example: walking).

• Min. engine idle speed in km/h - minimum idle speed, below which idle status will be detected.

• Min. difference between track points - this option helps to eliminate inaccurate GPS device location points (drifting).

• Min. gpslev value - location point filtering according to GPS signal strength.

• Max hdop value - location point filtering according to horizontal dilution of precision.

• Min. fuel difference to detect fuel fillings (default 10 %) - allows to set minimum amount (in percents) when sensor data changes will be recognized as fuel filling. (Example: if fuel level rises by 10% or more, it will be recognized as fuel filling). Note: In order to use this option, you must configure fuel sensor properly.

• Min. fuel difference to detect fuel thefts (default 10 %) - allows to set minimum amount (in percents) when sensor data changes will be recognized as fuel theft. (Example: if fuel level drops by 10% or more, it will be recognized as fuel theft). Note: In order to use this option, you must configure fuel sensor properly.

• Clear detected sensor cache - clears all detected device sensors.